Application: API 5CT is a standard technical specification of steel pipes that’s for casing and tubing in oil or gas industries. It can be used in oil or gas drilling and conveying.
API 5CT Steel grade refers to the yield strength of the products. Generally, the steel grade of API 5CT can be divided into the below categories:
Grade N-80 is a relatively old grade with essentially open chemical requirements. It is acceptable for sweet oil and gas wells. It can be further divided into two types: N-80-1 and N-80-Q. Both types share the same tensile strength but differentiate in delivery conditions.
Grade N80-1 can be either normalized or hot rolling.
Grade N80-Q must be through quenching-and-tempering heat treatment before delivery.
L-80 is a restricted yield-tubing grade which is divided into three types. L80-1, L80-9CR and L80-13Cr.
L80-1 is more subject to weight-loss corrosion. It is used commonly in many oil and gas fields because of higher strength..
L80-9CR and L80-13Cr are difficult to manufacture but they have strong corrosion resistance abilities. They are recommended to be used in heavily corrosive wells.
API 5CT is applicable to following connections which complied with API SPEC 5B:
Casing is the major structural part of a well. It is widely used for fastening oil and gas well wall or bore hold, with bigger diameter than tubing pipe, including surface casings, technical casings and oil layer casings. In practice, to prevent the wellbore from collapsing, a steel pipe should be installed and cemented in the wellbore. It can maintain borehole stability, prevent possible contamination of water sands, isolate water from producing formations and control well pressures during drilling, production, and operations.
Tubing basically means a tube running inside casing and serves as a channel through which oil and gas is produced. It must be adequately strong enough to resist loads and deformations associated with production and workovers. It should also be sized to support the expected rates of production of oil and gas. If the tube is too small, it would restrict production and subsequent economic performance of the well. If too large, however, it will have an economic impact beyond the cost of the tubing string itself, because the tubing size will influence the overall casing design of the well.
Application:
